Disinfectant dosage of technical and drinking water network
This dosing system is usually suitable for the dosage of disinfectants, but of course it can be used to ingest other chemicals and liquids into the
water flow.
The amount of water to be disinfected is measured by a water meter, which – in the proportion
of the flowed water – sends pulse sequence to the dosing pump. The pump processes the incoming signals, and based on these signals it carries
out the dosage in the pre-set quantity.
If the produced solution runs out shortly after the dosing point or after a short period, or the dosage is very discontinuous, the installation of a
static mixer into the pipes is recommended. The dosage amount can be set free, degree-free adjustable, even during the dosage.
Required to run: voltage, 230 VAC,
Advantage: Buffer tank is not required for the disinfection,
as it can be solved directly in the pipes.